irst of all, before you operate the vertical injection molding machine, you need to be fully prepared. Our staff should look at the electrical control box and the status of each component is normal. At the same time, we should also check the hydraulic oil's own oil level. If the stored oil is not sufficient, the machine's work will be affected. If the oil is not normal, it should be adjusted in time. In the preparation work, the last step is to connect the cooling water valve and the cooling water.
Secondly, when the staff is working on the vertical injection molding machine, it is important to remember to push the mechanism to the highest place and put the fixed template down. The fixed template and the upper mold screw need to be tightened to maintain its stability. To run the model, it is necessary to observe its position in this process. After everyone has done the process of molding, it is necessary to heat the barrel. The electric switch of the control box should be connected, and then some plastic is added to the barrel to allow the plastic to be fully heated and melted. .
Care should be taken during the injection molding operation to ensure that the vertical injection molding machine mold and the mold are closed. After the completion of the injection molding operation, it is also necessary to withdraw the injection plunger, and then the 8 solenoid valve is turned on to lower the mechanism, and the mold is opened in the demold mode. The correct workflow is important in the operation, but at the same time it should be noted that proper maintenance and repair should be done.